EarthQuaker Devices Erupter Fuzz Pedal
Hover over image to zoom.

EarthQuaker DevicesErupter Fuzz Pedal

Code: EQDERU
£159.00 (Free UK Delivery)
Item in Stock  |  Usually dispatched within 24 hours
Add to Basket
This product has been added to your basket...
  • Continue Shopping
  • Checkout

Controls

Bias: This control has a center detent for the "perfect" fuzz setting. When in the center position, the tone will be big and round with a slight volume boost and great sustain. As you turn this counter clockwise it becomes more gated with lower output. As you turn this clockwise it becomes louder and more refined.

Measures

4.75″ x 2.50″ x. 2.25″ with knob

Power

The Erupter can be powered by a 9v battery or a standard 9-volt DC power supply with a 2.1 mm negative center barrel. We always recommend pedal-specific, transformer-­isolated wall-wart power supplies or multiple isolated­-output supplies. Pedals will make extra noise if there is ripple or unclean power. Switching-type power supplies, daisy chains and non-pedal specific power supplies do not filter dirty power as well and let through unwanted noise. Do not run at higher voltages!

Current draw is 15 mA.

Ultimate Fuzz Tone

Can we ask you a serious question? When’s the last time you turned up your favorite fuzz pedal to anything but eleven? If there’s one true thing about rock n’ roll, it’s that it sounds best cranked all the way up. But where do we go from here? We go one louder. Enter the Erupter.

The Erupter is the result of over two years’ worth of tone-chasing, tweaking, and experimentation in search of the ultimate classic fuzz tone with a big low end (but not too mushy), a biting top end without being too harsh, and just enough output to politely send a tube amp over the top.

We used every trick in the book to craft a classic fuzz Device that sounds good with any pickup type, anywhere in the chain (even before a wah pedal!) without any tone-sucking impedance mismatching. We build each Erupter with a buffered input section, transformer-based pickup simulation, new production 5% ½ watt carbon composition resistors, metallized polyester film capacitors, Sprague and BC electrolytic capacitors, and low-gain, hand-matched NOS silicon transistors to deliver a well-rounded and defined fuzz tone with just enough pummeling intensity, so you can rock n’ roll all night and still get to bed at a reasonable hour.

The Erupter’s simple control set stands in stark relief of its rigorous design process, and believe us, we tried everything. Adding controls, removing controls, measuring resistors, swapping transistors, trying different capacitor values, rolling dice, throwing darts at transformer spec sheets on the wall… Heck, we would have done William Burroughs-style circuit board cut-ups if we thought it would’ve worked. If it’s good enough for the Stones, it’s gotta be good enough for us, right?

Anywho, what we finally landed on is a super-simple single knob setup that allows you to bias the Erupter’s NOS silicon transistors for the perfect sound and feel, while still being touch responsive and cleaning up nicely when you roll back the guitar’s volume and tone controls.

Low “Bias” settings yield a rude, spongy fuzz tone with plenty of sag and a blossoming attack envelope that’s gated without entering “dying battery” territory. As the “Bias” control is increased, additional harmonics stack atop the input signal, producing a stiffer, more complex fuzz tone with a tighter response, increased output, and longer sustain. We had a custom center-detent pot made to fit the required resistance for the Erupter. When the Bias control is set at noon you will feel a little click. That means the pedal is perfectly biased to give the best possible fuzz tone.

The Erupter uses a fixed master output level and gain setting for the thickest fuzz possible and to push the full frequency range of the guitar out front when you kick it on. And we do hope you’ll kick it on often.

Each and every Erupter is built by the hands of real-life dream warriors in the foothills of Mt. Akron, Ohio.

We are a secure website working with Sagepay.

Here at Guitar FX Direct we are committed to customer satisfaction and want you to recieve your order as quickly as possible so you can get plugged in and enjoy your new Fx Pedal.

All UK orders are dispatched using Royal Mail and will need a signature upon delivery. If you place your order before 1pm Mon-Fri and the item is in stock we will dispatch the same working day.

Our standard delivery is currently FREE to the UK and usually takes from 3-5 working days but if you need it quick, Next day delivery is only £6.99. For example if you order before 1pm on a Monday you will receive your shiny new guitar pedal on the Tuesday! Please note if an order is placed on a Friday before 1pm with Next Day Delivery as the delivery option you will receive Monday, order after 1pm and it will be sent Monday and delivered Tuesday.

Guitar FX Direct ship worldwide usually with Royal Mail International signed for, European delivery time is usually between 5-10 days. If you have any questions regarding your delivery please drop us an email.

 

Guitar FX Direct have a 7 Day Hassle Free Returns Period. Return or exchange an item - our 100% money back guarantee.

In accordance with the Distance Selling Regulations, the customer has the right to cancel the contract at anytime up to 7 working days starting the day after delivery. Customers are responsible for the costs and arrangements of unwanted goods to Guitar Fx Direct.

Goods should be returned with the original packaging in good condition to avoid the products being damaged on their return journey. It is the customers responsibility to take reasonable care of the goods during the cancellation period.

Any return labels should not be placed directly on the item packaging. Please wrap any items to be returned in a protective layer and place any labels on this outer packaging.

 

Returns and Refunds

Refunds can only be made by the method originally used to pay for the goods. Credit/debit card refunds will be processed immediately and normally take 3-5 working days to show on the customer's account.

Goods that have been altered from their original condition in any way cannot be returned.

Goods cannot be returned as faulty where a specific defect in the product was brought to the attention of the customer at the point of sale.

 

 

Contact us for further information.

'); -->
EarthQuaker Devices